Seco-Larm Enforcer 3 Zones Alarm Pager System with Vibrating Receiver (E-37EV)

Description

Immediately receive notifications when your security system is triggered by setting up the Seco-Larm Enforcer 3-Zone Alarm Pager System with Vibrating Receiver. This complete alert system includes a transmitter that connects to almost any security system and a wearable pager that receives alerts from the transmitter. When your system is breached, the pager vibrates, sounds an audible alarm, and lights a colored LED to alert you.
Belt-clip receiver vibrates and sounds audible alarm
Color LEDs indicate which zone was activated
Transmitter has 1 positive and 2 negative trigger inputs
Receiver stores the last six pages for easy recall
Low battery and unattended page indicators
The transmitter connects to almost any type of security control panel, vehicle alarm system, or other monitoring system. It features three instant trigger inputs – one positive input for +12V outputs and two negative inputs for ground outputs. When any of these inputs is activated, the transmitter will trigger the receiver, which will alert you and light the input's corresponding LED indicator (Green, Orange, or Red).
Expandable System
As a code-learning receiver, the vibrating pager can be programmed to receive signals from up to three different transmitters, allowing you to monitor up to three zones within a half mile of the receiver. Additionally, each transmitter can signal an unlimited number of receivers, so multiple users can receive alerts. (Extra transmitters and receivers are sold separately). More than two million possible coding combinations help ensure that the system cannot be tampered with by unauthorized users.
Backup Memory
Designed for reliable, continuous operation, the receiver features EEPROM memory that stores transmitter codes for up to one year without power. The battery-powered receiver also has a low battery indicator to alert you when the batteries need to be replaced.
Contents
Transmitter
Paging Receiver (E-37RV)
(3) Mounting Screws
Radio Antenna Adapter Cord
NOTES:
The system requires an antenna (sold separately). Seco-Larm offers an external antenna, Model E-37ANT. The system also works with a CB antenna, or a car AM radio antenna when used with the included Radio Antenna Adapter Cord.
Batteries not included.
Transmitter
Number of Codes:
Over 2 million (factory pre-set)
Power:
12VDC
RF Output Power:
4W max.
Current Drain
Standby: 10mA
Active: 1A
Frequency:
27MHz
Antenna Impedance:
50 Ohms
Range:
Up to 1/2 mile in open air
Dimensions:
4-1/8 x 3-1/8 x 15/16 inches (105 x 79 x 33 mm)
Weight:
5.1 ounces (145g)
Receiver
Number of Codes:
Learns up to 3 transmitter codes
Power:
3VDC (2 AAA alkaline batteries, not included)
Battery Life:
Approx. 1 month
Current Drain
Standby: 1mA
Active (Beep): 20mA
Active (Vibrate): 50mA
Dimensions:
3 x 2-1/8 x 5/8 inches (76 x 54 x 16 mm)
Weight:
1.6 ounces (45g) (without battery)
Technical Details
Manufacturer Part No:
E-37EV